Pa-industries Advantage Sequential Servo Roll Feed SRF-5/8/12/16 Manuel d'utilisateur télécharger pdf (Page 8)

ULTRA ADVANTAGE SEQUENTIAL SERVO ROLL FEED 6/ 3/2002

In this case the wiring must be considered very carefully.

The backing up the material in a Press application requires:

- A cutter bottom position sensor to be wired to the control.

The backing up the material in a Punching Bench application requires:

- A cutter bottom position sensor to be wired to the control:

- A cutter top position sensor to be wired to the control.

For a comprehensive description, refer to the Ultra Advantage Servo Roll Feed Operation Manual and

electrical schematic A-18164-06.

1.6 RUNNING THE FEED

Put the Ultra Advantage Sequential into “Auto” by pressing the Cycle Start button. The Ultra

Advantage Sequential Servo Roll Feed will now follow the press until it is stopped by the

Operator, counter, emergency stop, or feed error.

TYPICAL 180 DEGREE FEED ANGLE (FROM 260 DEGREES TO 80

DEGREES) WITH MECHANICAL PILOT RELEASE IN A POWER PRESS

APPLICATION:

FIGURE 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Pa-industries Advantage Sequential Servo Roll Feed SRF-5/8/12/16 Manuel d'utilisateur Page 8